Owner`s manual

COMPRESSOR/LIMITER screen

Limiters are provided on each AUX1 through 8, MTX1 through 4,

and MAIN L and R.

ON button

This turns the LIMITER on/off.

IN meter

This shows the input level of the limiter. For stereo-linked

channels, two meters (L and R) are shown.

GR meter

This shows the amount of gain reduction for the limiter.

OUT meter

This shows the output level of the limiter. For stereo-linked

channels, two meters (L and R) are shown.

Parameter

This sets the parameter for the limiter.

THRESH knob

This adjusts the threshold level in a range of -40.0 dB to 0.0

dB.

ATTACK knob

This adjusts the ATTACK time in a range of 0.0 ms to 800.0

ms.

This is the time from when the input signal exceeds the

threshold level until the limiter effect reaches its maximum.

KNEE knob

This adjusts the KNEE in a range of HARD or SOFT1 to SOFT9

(ten steps). The way in which the limiter is applied to the

region near the threshold level can be adjusted between

steep (HARD) and gentle (SOFT9).

RELEASE knob

This adjusts the RELEASE time in a range of 0 ms to 8000 ms.

This is the time from when the input signal falls below the

threshold level until the limiter effect disappears.

In the fader module section, press [SEL] to select the

desired channel.

In the CHANNEL EDIT section, press [COMP].

When COMPRESSOR is selected as the compressor type,

COMPRESSOR is displayed in the title bar. For information on

how change the type, refer to “Changing between

COMPRESSOR/LIMITER” (p. 52).

LIMITER screen

Accessing the LIMITER screen

M-200i_e.book 53 ページ２０１３年６月２８日　金曜日　午後１時２７分