Owner`s manual

71
Effects, GEQ, External effects
Effects, GEQ, External effects
The M-200i has four internal GEQs (GEQ1 through 4) separately from the stereo effects.
GEQ1 through 4 can be inserted into CH1 through 32, MAIN L and R, AUX1 through 8, and MTX1 through 4.
You use the GEQ screen to operate GEQ1 through 4.
You can also change the effect type for FX1 through 4 to monaural GEQ.
1.
In the top panel’s DISPLAY section, press the [GEQ]
button.
The GEQ screen is displayed.
You can use the up and down cursor buttons to change GEQ1
through 4.
Selection of the input source and output destination is the same
as at the EFFECTS screen.
For information on how to select the input source and output
destination, refer to “Effect input/output settings” (p. 66).
You can store or recall settings of GEQs using effect library.
Effect library operations are performed at the FX LIBRARY screen.
1.
Access the GEQ screen.
2.
Move the cursor to the LIB button for the desired GEQ
among "GEQ 1-4" and press [ENTER].
For information on operations at the FX LIBRARY screen, refer to
the "Using the effect library" section (P.70).
You can only choose GEQ as a effect type on GEQ 1-4.
1.
Access the GEQ screen.
2.
Press [FUNC] to access the GEQ FUNCTION screen.
The operations available at the GEQ FUNCTION screen are as
follows:
About GEQs
INPUT OUTPUT
31-BAND GEQ
GEQ 1
GEQ
GEQ OUTPUT
SELECT
To CH 1 GEQ INSERT IN
To CH 32 GEQ INSERT IN
To AUX 1 GEQ INSERT IN
To AUX 8 GEQ INSERT IN
To MTX 1 GEQ INSERT IN
To MTX 4 GEQ INSERT IN
To MAIN L GEQ INSERT IN
To MAIN R GEQ INSERT IN
GEQ INPUT
SELECT
CH 1 GEQ INSERT OUT
CH 32 GEQINSERT OUT
AUX 1 GEQ INSERT OUT
AUX 8 GEQ NSERT OUT
MTX 1 GEQ INSERT OUT
MTX 4 GEQ INSERT OUT
MAIN L GEQ INSERT OUT
MAIN R GEQ INSERT OUT
Same as the above
GEQ 4
Same as the above
GEQ 2
Same as the above
GEQ 3
GEQ screen
Accessing the FX LIBRARY screen
GEQ FUNCTION screen
GEQ1-4 SOURCE This sets the insert channel for the specified GEQ.
BYPASS GEQ 1-4 This turns bypass on/off for the specified GEQ.
When these are on, the input signal will be “thru-ed”
to the output.
GEQ 1/2 (3/4)
LINK
This links the parameters between GEQ 1 and 2 (or
GEQ 3 and 4).
M-200i_e.book 71 ページ ２０１３年６月２８日 金曜日 午後１時２７分