Owner`s manual

92
Monitor/Solo
Monitor/Solo
fig.MonitorFlow.eps
Monitoring is a function by which the AUX, MTX, MAIN, or USB memory recorder signal that you select as the monitor source can be sent
from the output jacks or headphone jack. This is used mainly by a mixing engineer to monitor the signals.
The monitor output is split to the MONITOR OUT L/R and PHONES OUT, and the level of these two can be adjusted independently. You can
use the output patchbay to patch MONITOR OUT L/R to any desired output jacks.
Solo is a function by which the channel you select using a [SOLO] button is sent from the MONITOR OUT L/R or PHONES OUT jacks. This is
used to monitor a channel temporarily.
About monitoring
D/A
MONITOR OUT L
PHONES
LEVEL
PHONES OUT
MONITOR OUT R
MONITOR
SOLO
LEVEL
MONITOR
LEVEL
SOLO
LOGIC
AUX 1 OUT
AUX 8 OUT
MTX 1 OUT
MTX 4 OUT
MAIN OUT L
MAIN OUT R
MONO OUT
REC OUT LR
DIRECT OUT 1-32
TALKBACK / OSC
REAC INPUT 1-40
USB PLAYER L, R
INPUT 1–24
MONITOR
SELECT
DELAY
DELAY
DIMMER
DIMMER
DOCK INPUT L, R
OUTPUT
PATCHBAY
MONITOR
LR
SOLO
LR
SOLO
1.
In the top panel’s DISPLAY section, press [SETUP].
2.
At the SETUP screen, select “MONITOR“ and press
[ENTER].
The MONITOR screen is displayed.
Meter display
These indicate the levels of AUX, MTX, MAIN, and MONITOR.
MONITOR LEVEL
This adjusts the output level of the monitor in a range of -Inf
dB to +10.0 dB.
DELAY button
This turns delay on/off.
Delay time
This adjusts the amount of delay in a range of 0.0 ms to 400
ms (when milliseconds are used).
1.
Access the MONITOR screen.
2.
Press [FUNC] to access the MONITOR FUNCTION screen.
The operations available at the MONITOR FUNCTION screen are
as follows:
MONITOR screen
1
2
3
4
MONITOR FUNCTION screen
MONITOR
SOURCE
This selects the monitor source.
SOLO MODE This lets you select the solo mode from among the
following:
ADD ON : Channels for which [SOLO] is on are mixed
for monitoring.
LAST : Only the channel for which [SOLO] was turned
on most recently is monitored.
SOLO LEVEL This adjusts the solo level in a range of -Inf dB to
+10.0 dB.
The solo output level is adjusted not only by
SOLO LEVEL, but also by “MONITOR LEVEL“
or the “PHONES jack LEVEL knob.“
M-200i_e.book 92 ページ ２０１３年６月２８日 金曜日 午後１時２７分