Owner`s manual

45
Changing the Pad Parameters
Specify the volume.
When you press a pad to play a movie, it plays back in
reverse.
When you press a pad to play a movie, it plays back with
strobe.
“Strobe” is an effect that plays back a movie with short
intervals between frames, creating a stop motion feel.
You can specify the time interval for the strobe effect.
For example, if you specify “0.5sec,” the movie plays in 0.5
second strobe bursts.
You can add still images to a pad that has a still image
assigned to it.
1. Select the pad to which you want to add still images.
Pads that have still images assigned to them light up
blue.
2. Press the [PAD PARAM] button.
3. Rotate the [VALUE] knob to select “Still Image File,”
and then press the [ENTER] button.
The STILL IMAGE LIST screen appears.
D05_06.eps
4. Rotate the [VALUE] knob to select “Add Still Image,”
and then press the [ENTER] button.
The FILE SELECT screen appears.
D05_07.eps
5. Rotate the [VALUE] knob to select the still image that
you want to add.
6. Press the [ENTER] button.
The still image is added to the pad.
Specifying the Volume (Audio Level)
Setting
Description
MAX
This is the maximum volume.
1–9
Specify the volume level with a number.
The higher the number you set, the higher
the volume becomes.
OFF The volume is set to “0.”
Specifying the Reverse Effect
(Reverse Sw)
Setting
Description
ON
Turns reverse on.
OFF Turns reverse off.
Specifying the Strobe Effect (Strobe Sw)
Setting
Description
ON
Turns strobe on.
OFF Turns strobe off.
Specifying the Strobe Interval
(Strobe Time)
Setting Description
0.5sec–2.0sec Specify the interval in 0.1 second units.
Still Images
Adding Still Images to a Pad
(Add Still Image)
P-10_e.book 45 ページ ２００８年７月１６日 水曜日 午後８時２３分