Owner`s manual

7
IMPORTANT NOTES
Take care not to pinch your fingers between the KD-85
pad and the stand plate.
1. Place the KD-85 pad, with the head surface
facing downward, on a flat surface such as the
floor.
2. Use the tuning key supplied with the VH-11 to
loosen the bolts for the bracket on the back of
the KD-85 pad, then open the bracket.
3. Mount the stay on the pad.
Align the mark on the stay with the protrusion of the
bracket, and use the tuning key to firmly tighten the bolts
that you loosened in step 2 .
fig.Stay.e
4. Loosen the leg nut.
5. Rotate the rubber foot to adjust the leg tip.
Adjust to use the spike legs when installing on carpeting
or other soft surfaces, or the rubber legs when installing
on flooring or other hard surfaces. When shipped from
the factory, the stand is adjusted for using the rubber
legs.
fig.Leg1.e
• The tip of the spike is sharp. Handle it with care.
• When using on flooring, the spike legs may damage the
floor. Adjust to use the rubber legs.
6. Tighten the nut and rubber foot to secure the
rubber foot in place and keep it from loosening.
The nut and rubber foot must be tighten to prevent the
malfunctions.
7. Loosen the T-bolts for the stay and mount the
legs on the stay.
Install the legs as shown in the figure so that the ends of
the legs protrude by about 1/2"–1" (1–2 cm).
fig.Leg2.e
8. Tighten the T-bolts to secure the legs to the
stand.
9. Lift the KD-85 and place the stand and the four
legs upright.
10. Adjust the angle of the stand plate so that it’s at
a right angle to the floor.
Loosen the T-bolts that you tightened in step 8 , and
adjust the length of the legs so that the stand plate is
vertical to the floor. Then firmly tighten the T-bolts.
11. Install the included beater on your kick pedal.
12. Mount the kick pedal on the KD-85.
fig.Pedal.e
* Install the kick pedal securely.
* Set the KD-85 so no mechanical noise is heard when you step
on pedal.
* Make sure that KD-85 does not touch the drum stand or the
other pads.
Assembling the KD-85
Align the marks
Bolt
Spike
Rubber Foot
Nut
Spike Leg Rubber Leg
Extend the leg
by about 1/2"–1"
(1–2 cm).
90°
60°
Adjust
the leg length
Adjust
the stay angle
Stand plate
Under plate
Heel portion
TD-12K_e 7 ページ ２００７年１月５日 金曜日 午後１時２７分