User Manual

Pattern Sequencer
102
Copying a Pattern (COPY)
Copy the pattern as is to the user patterns.
Src
Dst
1
1
2
2
3
3
4
4
5
5
6
6
8
8
7
7
You can copy selected measures of a part or pattern.
Unlike copying an entire pattern, settings such as
instrument and part volume etc. will not be copied.
Src
Dst
1
1
2
2
3
3
4
4
5
5
6
6
8
8
7
7
1. In the PATTERN EDIT screen (p. 101), press the [F1]
(COPY) button.
The PATTERN COPY screen will appear.
2. When you want to copy selected measures or
part, press the [F4] (MEASURE) button.
The PATTERN COPY MEASURE screen will appear.
3. Use the cursor buttons and the [–] [+] buttons or
the dial to select the pattern, part, or measures
that you want to copy.
Copy-source pattern
Copy-destination pattern
Copy-destination part
Copy-source part
Measures to be copied
(First Measure–Last
Measure)
First measure of the
copy-destination
4. Press the [F5] (COPY) button.
A conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
5. Press the [F5] (EXECUTE) button.
The pattern will copied.
MEMO
• If the number of measures in the copy-source pattern
and the copy-destination pattern dier, the number
of measures in the copy-destination pattern may
increase or decrease according to this dierence.
• When “ALL” is specied in Src part, then only “ALL”
may be specied in Dst Part. Additionally, if other
than “ALL” is specied in Src part, then “ALL” cannot be
specied in Dst Part.
• When copying between the drum kit part and the
percussion part, or between the drum kit part and
the backing parts, copy takes place in accord with
the predetermined correspondence between note
numbers and trigger inputs. Only note numbers
assigned to trigger inputs will be copied. For more
on note numbers and trigger inputs, refer to “Note
Number (Factory Settings)” (p. 150).