User Manual

MIDI Settings
143
Parameter Value Explanation
Local Control
OFF
Performance data from
the pads will not be sent
directly to the drum kit
part of the TD-30’s internal
sound generator; it will
be transmitted via your
external sequencer.
ON (DRUM)
The performance data
from the pad is sent to the
drum kit part. Normally
set to this.
ON (PERC)
The performance data
from the pad is sent to the
percussion part and drum
kits cannot be played.
Select this only when you
record the percussion part
with pads.
* If Local Control is “ON (PERC),” you won’t be able to
play the drum kit from the pads, so the sound will not
change even if you switch kits.
Setting the Device ID
The setting described here is necessary only when you
wish to transmit separate data to two or more TD-30
units at the same time. Do not change this setting in any
other case. (At the factory settings, the device ID is set to
“17.”)
Parameter Value Explanation
Device ID 1–32 Device ID setting
MIDI Message Settings
for Detailed Performance
Expression (CTRL)
Here you can specify the MIDI messages that will be
transmitted and received according to the position of
your strikes on the pad and the depth to which you press
the hi-hat.
1. In the SETUP B screen (p. 114), press the [F3] (MIDI)
button.
2. Press the [F3] (CTRL) button.
The MIDI CONTROL screen will appear.
3. Use the cursor [ ] [ ] buttons to select the
parameter.
4. Use the [–] [+] buttons or the dial to make
settings.
Parameter Value Explanation
Pedal CC
OFF,
MODULATION (1),
BREATH (2),
FOOT (4),
EXPRESSION (11),
GENERAL1 (16)–
GENERAL4 (19)
Control change used for
transmitting/receiving the
depth to which the hi-hat
pedal pressed
Snare CC
Control change used for
transmitting/receiving the
strike position of the snare,
ride, tom 1–4, and AUX 1–4
Ride CC
Toms/AUXs
CC
Kit Volume
Rx Sw (CC#7)
OFF, ON
(Initial Value: OFF)
Specify whether MIDI Volume
messages (CC #7) will be
received (ON), or not (OFF)
for drum kit part (p. 141).
HH Note#
Border
0–127
This number species the
pedal position at which to
switch from open hi-hat to
closed hi-hat (p. 144).
* There’s no need to change
this setting if you’re
performed and recording
only with the TD-30 and
the pads.
MEMO
When a control change is set to be more than one
parameter, an asterisk (*) appears at the right of the
unavailable parameter.
5. Press the [KIT] button to return to the DRUM KIT
screen.
AppendicesExpansionSettingsPerformanceSetupOverview