User Manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Contents
- Overview
- Setup
- Performance
- Drum Kit
- Instrument
- Mixer
- Effects
- Tempo
- Song Player
- Pattern Sequencer
- Settings
- Backing Up the Settings
- Data saved in USB flash drive
- Backing Up All Data to a USB Flash Drive (SAVE)
- Loading Backup Data from a USB Flash Drive (LOAD)
- Importing Kit Data from TD-20/TD-20X Backup Data (IMPORT)
- Deleting Backup Data from a USB Flash Drive (DELETE)
- Backing Up a Drum Kit to a USB Flash Drive (KITSAVE)
- Loading Kit Data from a USB Flash Drive (KITLOAD)
- Checking the State of a USB Flash Drive (INFO)
- Formatting a USB Flash Drive (FORMAT)
- Overall Settings for the TD-30 (SETUP)
- Output Assignments (OUTPUT)
- Assigning a Function to a Footswitch or Pad (CONTROL)
- Other Settings (OPTION)
- Restoring the Factory Settings (F RESET)
- Playing a Kit from the USB Flash Drive Without Loading It (Kit Selection) (KIT SEL)
- Digital Audio Level (GAIN)
- Auto Off Function (AUTOOFF)
- Viewing the Remaining Memory and the Program Version (INFO)
- Trigger Settings
- Backing Up the Settings
- Expansion
- Appendices
40
Adjusting the Hi-Hat and Mesh Pads
Making Hi-hat Settings
If you’re using the VH-13, VH-12, or VH-11 V-hi-hat, adjust the oset on the TD-30.
This adjustment is required for pedal movements such as open or close to be detected correctly.
* If you do not make hi-hat’s setting correctly, it may cause malfunction. For details on attaching the hi-hat to the stand, refer
to the owner’s manual of each device.
Settings for the VH-13/VH-12
1. Set the Trigger Type for hi-hat to “VH13” (or “VH12”) (p. 126).
2. In the TRIGGER HI-HAT screen (p. 128), press the [F4] (OFFSET) button.
The VH OFFSET ADJUSTMENT screen will appear.
MEMO
You can also adjust the oset by holding down the TD-30’s [KIT] button and pressing the [TRIGGER] button.
3. Loosen the clutch screw of the top hi-hat and let it sit on the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
4. Press the [F5] (EXECUTE) button.
The “VH Oset” parameter is set automatically (approx. 3 seconds).
The [TRIGGER] button stops ashing and remains lit.
MEMO
If you need, make further adjustments to the parameters, refer to “Hi-Hat Settings (HI-HAT)” (p. 128).
Settings for the VH-11
1. After making the hi-hat settings, release your foot from the pedal, and while keeping your foot o the pedal,
turn on the unit to the TD-30.
2. Loosen the clutch screw and let the hi-hat rest naturally on the motion sensor unit.
3. Press the [TRIGGER] button.
4. Press the [F3] (HI-HAT) button.
The TRIGGER HI-HAT screen will appear.
5. Set the Trigger Type for hi-hat to “VH11” (p. 126).