User Manual

Eects
73
STEREO DELAY
This is a stereo delay.
Parameter Value Explanation
BPM Sync OFF, ON
OFF: Time specied as
numerical value
ON: Time specied as note
value
Time Left 0–1300 msec, note
Adjusts the delay time
from when the direct
sound begins until the left
delay sound is heard.
Time Right 0–1300 msec, note
Adjusts the delay time
from when the direct
sound begins until the
right delay sound is heard.
Feedback -98–+98 %
Proportion of the
delay sound that is to be
returned to the input.
Negative(-) settings invert
the phase.
Phase Left NORMAL, INVERSE Phase of the delay sound
Phase Right NORMAL, INVERSE Phase of the delay sound
Wet Gain Low -15–+15 dB
Amount of boost/cut for
the eect sound’s lower
range
Wet Gain High -15–+15 dB
Amount of boost/cut for
the eect sound’s upper
range
REVERSE DELAY
This is a reverse delay that adds a reversed sound of the
input sound as a delayed sound. A chorus is connected
immediately after the reverse delay.
Parameter Value Explanation
Threshold 0–127
Volume at which the
reverse delay will begin to
be applied
BPM Sync OFF, ON
OFF: Reverse delay time
DlyTime specied as
numerical value
ON: reverse delay time
DlyTime specied as note
value
DlyTime 0–1300 msec, note
Delay time from when
sound is input into the
reverse delay until the
delay sound is heard
Feedback -98–+98 %
Proportion of the
delay sound that is to
be returned to the input
of the reverse delay.
Negative(-) settings invert
the phase.
TAPE ECHO
Simulates a tape-type echo unit of the past.
Parameter Value Explanation
Rate 0–127 Tape speed
Intensity 0–127 Amount of echo repeat
CHORUS
This is a stereo chorus. A lter is provided so that you can
adjust the timbre of the chorus sound.
Parameter Value Explanation
PreDelay 0.0–100 msec
Adjusts the delay time
from the direct sound
until the chorus sound is
heard.
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
Phase 0–180 deg
Spatial spread of the
sound
Filter Type OFF, LPF, HPF
Type of lter
OFF: no lter is used
LPF: cuts the low
frequency range
HPF: cuts the high
frequency range
Cuto 200–8000 Hz
Center frequency when
using the lter to cut a
specic frequency range
PHASER
A phase-shifted sound is added to the original sound
and modulated.
Parameter Value Explanation
Mode
4-STAGE, 8-STAGE,
12-STAGE
Number of stages in the
phaser
Manual 0–127
Adjusts the basic
frequency from which the
sound will be modulated.
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
Resonance 0–127 Amount of feedback
AppendicesExpansionSettingsPerformanceSetupOverview