User Manual

Pattern Sequencer
93
Tuning Settings for the Backing Parts
(Master Tuning)
Here you can adjust the overall tuning for the backing
parts.
1. In the PATTERN PART screen (p. 91), press the [F2]
(BACKING) button.
2. Press the [F5] (M TUNE) button.
The MASTER TUNE screen will appear.
3. Use the [–] [+] buttons or the dial to make
setting.
Parameter Value
Master Tune 415.3–466.2 Hz
You can set this to 440.0 Hz by pressing the [F5] (440 Hz)
button.
4. Press the [EXIT] button twice to return to the
PATTERN PART screen.
Percussion Part Settings (PERC)
An assembled group of dierent percussion instruments
is called a “percussion set.” Since each note number
has been assigned a dierent percussion instrument, a
multiple number of instruments can be played at one
time.
Choosing a percussion set
1. In the PATTERN PART screen (p. 91), press the [F3]
(PERC) button.
The PERCUSSION PART screen will appear.
2. Use the [–] [+] buttons or the dial to select the
percussion set.
About the Percussion Sets
The TD-30 features eight percussion sets.
You can select which percussion set is to be used
in each pattern in the PERCUSSION PART screen.
Pattern
Pattern 1
Pattern 2
Pattern 101
Pattern 200
Percussion set
Percussion set 1
Percussion set 3
Percussion set 2
Percussion set 8
Changing a percussion set’s instrument settings
simultaneously changes the percussion
instruments in patterns using the same percussion
sets.
MEMO
The preset patterns use percussion sets 1–5.
If you change the percussion set settings,
it is recommended that you rst copy the
percussion set you want to change to
percussion set 6 or other percussion set, then
change the settings in the copy.
AppendicesExpansionSettingsPerformanceSetupOverview