Owner`s manual
15
Driver Installation
5. When a conrmation screen regarding user account control appears, click [Yes]
or [Continue].
6. When “The TRI-CAPTURE Driver will be installed on your computer.” appears,
click [Next].
7. Click [Next] again.
Windows 8/Windows 7/Windows Vista
If a dialog box regarding Windows security appears, click [Install].
Windows XP
If the “Software Installation” dialog box appears, click [Continue] to proceed with the
installation.
If you cannot proceed, click [OK] to cancel the installation. Change the settings as
described in “Driver Signing Options Setting (Windows XP)” (p. 36) and try installing again.
8. When “Ready to install the driver.” appears,
connect the TRI-CAPTURE to the computer
using the USB cable.
* Turn down the volume on any peripheral devices
before connecting the USB cable.
* This unit is equipped with a protection circuit. A
brief interval (a few seconds) after power up is
required before the unit will operate normally.
* Before switching the power on/o, always be sure to
turn the volume down. Even with the volume turned
down, you might hear some sound when switching the power on/o. However, this is
normal and does not indicate a malfunction.
* It may take several minutes for the driver to be installed.
Windows 8/Windows 7/Windows Vista
If other messages appear, follow the instructions on the screen. The driver will be installed
automatically.
Windows XP
“Found new hardware” will appear in the lower-right corner of the screen.
Windows 8/Windows 7/Windows Vista users: continue to p. 16
Windows XP users: continue to p. 17
Windows