Owner`s manual
23
■
Setting the driver
The following describes the settings enabling use of the UM-2EX with sequencer software using
Macintosh standard device settings.
If you are using sequencer software that does not utilize Macintosh standard device settings, make
the device settings within the sequencer software.
* What you actually see on your Macintosh screen may be different, depending on your computing
environment and the operating system you’re using.
1.
Set the UM-2EX’s
ADVANCED (mode select) Switch
to the
ON
position.
2.
Connect the UM-2EX to your Macintosh.
* Connect the cable to the USB connector of the Macintosh itself, not to the USB connector of the keyboard.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting the UM-
2EX is required before the unit will operate normally.
3.
Open the
Applications
folder of your Macintosh hard disk. In the
Utilities
folder, double-click
Audio MIDI Setup
to open the
Audio MIDI Setup
dialog box.
4.
Click the
MIDI Devices
tab.
5.
Confirm that
UM-2
appears in the
Audio MIDI Setup
dialog box.
* If
UM-2
does not appear or if it is grayed out, it means that the UM-2EX is not being recognized properly.
Click
Rescan MIDI
. Also try disconnecting and reconnecting the UM-2EX.
* Previous settings from installation of a different version of the driver may still remain. If this is the case,
click on the grayed
UM-2
or
EDIROL UM-2
to select it, then click
Remove Selected Device
to delete
the settings.
6.
Click
Add Device
twice.
Two
new external device
will appear.
Operation of the UM-2EX
Operation of the UM-2EX
4
7
6
Click MIDI Devices
Click Add Device
Click Show Info
UM-2EX_multi1.book 23 ページ ２００５年１１月１日 火曜日 午後３時４７分