Owner`s manual

26
■
Installing the UM-2 driver
Use either OMS or FreeMIDI as the MIDI driver.
The included UM-2 driver is an add-on module for using the UM-2EX with OMS or FreeMIDI.
OMS can be found in the OMS 2.3.8 E folder within the OMS (Mac OS 9) folder of the CD-ROM.
If you would like to know more about OMS, refer to OMS_2.3_Mac.pdf which can be found in the
same folder.
* Either OMS or FreeMIDI must be installed in your Macintosh, as appropriate for the sequencer software
you are using.
* If you install OMS after installing the UM-2 driver, you must install the UM-2 driver once again.
Use the following procedure to install the UM-2EX driver.
1. With the UM-2EX left unconnected, start up Macintosh
* Disconnect all USB cables other than those for your keyboard and mouse, and restart your Macintosh.
2. Exit all currently running software (applications).
3. Prepare the CD-ROM. Insert the CD-ROM into the CD-ROM drive of your Macintosh.
4. Double-click the UM-2 Driver-E Installer icon (found in the Driver E (Mac OS 9) folder of the CD-
ROM) to start up the installer.
Mac OS 9 users
If a UM-2EX is already connected to your Macintosh when you install the driver, a message like
the following will appear when the Macintosh is started up. Perform the steps described below as
appropriate for the message that is displayed.
If the screen indicates:
“Software needed for the USB device “UM-2” is not available. Would you like to look for
the software on the Internet?”➔ click [Cancel].
UM-2EX_multi1.book 26 ページ ２００５年１１月１日 火曜日 午後３時４７分