Owner`s manual

12
Part Names and Functions
5 Setup Buttons
Use these to make the settings for transition eects, lter eects etc. (p. 26).
6 MEMORY Dial
You can save the current settings of the V-4EX to the dierent positions on the dial (p. 37).
* When [1] has been selected, settings can be changed, but cannot be saved.
7 A-bus Input Selectors
These select the channel to be sent to A-bus.
8 A-bus Eect Buttons
These apply eects to the video sent to A-bus.
* By default, from top down, the assigned eects are Strobe, Negative, Colorize, and Multi.
9 A-bus Eect Control Dial
This changes the amount of eect applied to the video on A-bus in a smooth and continuous manner.
10 A-bus Transformer
Pressing this performs a transition for the video on A-bus. The video on A-bus is displayed while the button is depressed (p. 29).
* By default, the transition is made using a cut. You can also use menu settings to apply a transition eect.
11 MONITOR Buttons
These switch the view mode for the monitor.
12 OUTPUT FADE Dial
This applies fade to nal output. Turning counterclockwise applies a fade-out to black, and turning clockwise applies a fade-out to
white. To apply a fade-in, return the dial to its center position (p. 31).
* The indicator ashes when the dial is at any position other than center.
13 FREEZE Button
This freezes the nal output. It lights up while the still video is being output. Pressing the control a second time makes it go dark
and ends the output freezing (p. 31).
14 B-bus Input Selectors
These select the channel to be sent to B-bus.
15 B-bus Eect Buttons
These apply eects to the video sent to B-bus.
* By default, from top down, the assigned eects are Mirror, Chroma Key, Luminance Key, and Picture-in-Picture.
16 B-bus Eect Control Dial
This changes the amount of eect applied to the video on B-bus in a smooth and continuous manner.
17 B-bus Transformer
Pressing this performs a transition for the video on A-bus. The video on A-bus is displayed while the button is depressed (p. 29).
* By default, the transition is made using a cut. You can also use menu settings to apply a transition eect.
18 Transition Section
Use this section when switching between the A-bus video and the B-bus video. For information on part names and functions, refer
to the following page.