Owners Manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Panel Descriptions
- Basic Operations
- Video Input/Output Settings
- Video Operations
- Video Composition Operations
- Audio Operations
- Adjusting the Volume Level
- Outputting AUX-bus Audio
- Applying Effects to Audio
- Controlling Volume Levels Automatically (Auto Mixing)
- Muting Out Specific Input Audio (Mute)
- Interlinking Audio Output to Video Switching (Audio Follow)
- Separating Discrete Analog Input Audio Streams and Adding Them to SDI Video
- Other Features
- Saving/Recalling Settings (Preset Memory)
- Saving the Unit’s Settings on a USB Flash Drive
- Formatting USB Flash Drives
- Returning Settings to the Factory-default State (Factory Reset)
- Preventing Unintended Operation (Panel Lock)
- Operating the V-60HD by Remote Control
- Outputting a Tally Signal
- Using Smart Tally
- Appendices
29
Audio Operations
Interlinking Audio Output to Video Switching (Audio Follow)
You can associate audio with a video switch so that when the video is switched, the specied audio alone is output automatically, and other
audio is automatically muted.
NOTE
When the Audio Follow feature is turned on, switching between audio output and muting is carried out automatically.
The positions of the controls used to adjust the volume level do not change automatically.
1. Follow the procedure in “Adjusting the Volume Level” (p. 24)
to adjust to the volume level you want to output.
2. Select the [MENU] button
0
“AUDIO FOLLOW.”
3. Select the video channel you want to use with Audio Follow,
then use the [VALUE] knob to set it to “ON.”
Value Explanation
ON
This enables the Audio Follow feature.
Muting is performed automatically when video on another
channel is output.
OFF This disables the Audio Follow feature.
4. Press the [VALUE] knob to apply the setting.
5. Press the [MENU] button to quit the menu.
6. Switch the video.
On video channels where Audio Follow is on, audio is automatically
muted when video on other channels is output.
MEMO
You can check the Audio Follow settings by examining the
channel section of the multi-view monitor. Video channels for
which Audio Follow is turned on are displayed together with
an “A.F” symbol.
Applying audio follow to AUDIO IN 1–5/6
1. Select the [MENU] button
0
“AUDIO FOLLOW.”
2. From among “AUDIO IN 1” through “AUDIO IN 5/6,” select the
input audio you want to use with Audio Follow.
3. Use the [VALUE] knob to specify the video channel to use
with Audio Follow.
Value Explanation
SDI IN 1–4
HDMI IN 5
HDMI/RGB IN 6
STILL/BKG IN 7 and 8
This sets the video channel to interlink with
input audio using Audio Follow.
Audio from AUDIO IN 1–5/6 is muted out for
video channels other than what you specied.
OFF This assigns no video channel to Audio Follow.
4. Press the [VALUE] knob to apply the setting.
5. Press the [MENU] button to quit the menu.