User Manual
Mounting on the Hi-Hat Stand
6
(2) Assembling the Bottom Hi-Hat
1. Remove the clutch included with the hi-hat
stand from the cymbal rod.
* The clutch included with the hi-hat stand will not be
used.
* It is not necessary to remove the felt (or rubber) pad
on the hi-hat stand used for supporting the bottom
cymbal.
2. Conrm that the cymbal rod is rmly secured.
* For instructions on tightening the cymbal rod, refer to
the owner’s manual for your cymbal stand.
Cymbal Rod
* Looseness or play in the cymbal rod can make the
top hi-hat unstable, causing it to shake or turn, and
prevent proper functioning.
3. Place the bottom hi-hat on the hi-hat stand with
the cymbal rod passing through the bottom
hi-hat hole.
If your unit allows the angle of the cymbal receiver to be
adjusted, adjust it to the horizontal position. Malfunction
may occur if this is tilted.
At this point, position the
mark so it’s facing the
performer.
Hi-hat stand felt (or rubber)
cymbal pad
At this point, position the LINK jack so it’s on the far side
of the unit, facing away from the performer.
LINK jack
4. Select the holder that matches the diameter of
the pipe at the top of the hi-hat stand.
There are three holders to match dierent pipe
diameters.
L: 25.4 mm (1”)
M: 22.2 mm (7/8”)
S: 19.1 mm (3/4”)
5. Remove the clamp bolt, then t the holder and
the clamp so they are nested together.
L L M M
S S
L
M
S
25.4 mm
(1”)
22.2 mm
(7/8”)
19.1 mm
(3/4”)