Owner`s manual

83
Advanced Use
❍ PEDAL ORCHESTRAL TONES MONO MODE
(POLYPHONY/MONO)
This setting determines whether the Pedal Orchestral
Tones are played with multiple or single notes.
Turn the [VIBRATO AND CHORUS] knob to the left to
select POLYPHONY, or to the right to select MONO.
■ Pedal Sustain Setting
❍ PEDAL SUSTAIN TIME (0–127)
This sets the length of the sustain following release of the
keys when the PEDAL [SUSTAIN] button is on. The
length of the sustain increases as the value is increased
1. Hold down the [BANK] button and press the PEDAL
[SUSTAIN] button.
The indicators of PEDAL [SUSTAIN] button will blink.
2. Turn the [VIBRATO AND CHORUS] knob to adjust
the setting.
If you press the VIBRATO AND CHORUS [UPPER]
button, the setting will return to its initial value.
When you want to stop editing, press the [H-BAR
MANUAL] button.
3. Press the [WRITE] button to confirm the settings.
4. Save the finalized parameter settings in a registration
(p. 48).
NOTE
Never turn off the power while registration are being
saved.
■ Pedal Attack Setting
1. Hold down the [BANK] button and press the PEDAL
[ATTACK] button.
The indicators of buttons [1]–[2] will blink.
2. Press one of the buttons from [1] through [2] to select
the parameter that you want to edit.
There are two parameters related to Pedal Attack.
The following parameters are assigned to each button.
3. Turn the [VIBRATO AND CHORUS] knob to adjust
the setting.
If you press the VIBRATO AND CHORUS [UPPER]
button, the setting will return to its initial value.
When you want to stop editing, press the [H-BAR
MANUAL] button.
4. Press the [WRITE] button to confirm the settings.
5. Save the finalized parameter settings in a registration
(p. 48).
NOTE
Never turn off the power while registration are being
saved.
❍ PEDAL ATTACK TIME (0–127)
Specify the decay time of the attack sound when the
PEDAL [ATTACK] button is on. Increasing this value will
cause the attack sound to decay more slowly.
❍ PEDAL ATTACK LEVEL (0–127)
Specify the volume of the attack sound when the PEDAL
[ATTACK] button is on. Increasing this value will increase
the volume of the attack sound.
Button Parameter Page
[1] PEDAL ATTACK TIME p. 83
[2] PEDAL ATTACK LEVEL p. 83