Owner`s manual

94
Troubleshooting
Can’t hear the 1' harmonic bar
PERCUSSION is turned on.
If PERCUSSION is on, the sound of
the 1' harmonic bar will not be
heard.
This is not malfunction. - - -
Rotary changes to FAST
unintentionally
“CRESCENDO” is assigned to the
control pedal, D BEAM, aftertouch,
or MODULATION lever.
When “CRESCENDO is assigned to
the control pedal, D BEAM,
aftertouch, or MODULATION lever
with the [SLOW/FAST] button set
to SLOW, then the rotary switches to
FAST when you press the control
pedal down completely, or position
your hand very near to the D BEAM.
Assign a function other than
“CRESCENDO to the control pedal,
D BEAM, aftertouch, or
MODULATION lever.
Alternatively, when you release
your foot from the control pedal, or
move your hand away from the D
BEAM, or release the upper keys or
MODULATION lever, the rotary
switches back to SLOW.
p. 42
p. 58
p. 69
p. 70
Hold pedal or control pedal
operation is reversed
The control pedal’s polarity is
reversed.
Depending on the type of pedal
switch or expression pedal, it may
have the opposite operation when
depressed. Switch the polarity of the
control pedal.
p. 80
D Beam sensitivity is incorrect
Something covered the D BEAM
while the sensitivity was being
adjusted.
When adjusting the sensitivity, do
not place any object on the D BEAM
or cover it with your hand.
p. 44
D Beam sensitivity is incorrect.
Readjust the sensitivity of the D
Beam.
p. 44
The instrument is placed in a
location where there is a large
amount of infrared light.
The D Beam will not function
correctly in a location where there is
a large amount of infrared light.
p. 44
Registration memory contents
are lost
The power was turned off while
data was being written into
registration memory.
Never turn off the power while data
is being written into registration
memory.
- - -
Can’t select Orchestral Tones
The VK-88 is in Edit mode. Exit Edit mode. p. 63
The VK-88 is in Demo mode. Exit Demo mode. p. 28
The volume level of the
instrument connected to VK-88 is
too low
Could you be using a connection
cable that contains a resistor?
Use a connection cable that does not
contain a resistor.
- - -
Problem Check Solution Page