Owner`s manual

118
Chapter 8 Using the Internal Effects
■ Naming effects libraries
You can also name the effect libraries. We suggest that you give them meaningful
names which allow you to readily know their intended use or effect.
Calling up the screen for setting effect library names
(Steps marked * are not required for the master effect.)
1. Invoke the Effect screen menu.
For effects 1 to 8, press [EFFECTS 1-8], or for the master effect, press [SP MODELING
(MASTER FX)].
fig.08-002
2. Select the effect column to use with CURSOR [UP] and [DOWN] (*).
The effects appear on the screen in the following order from top to bottom: 1 to 3, 4
to 6, and 7 to 8.
3. Invoke the Edit Effect screen.
Press EDIT for the desired effect. ([F2], [F4] or [F6]. [F2] for the master effect.)
4. Select NAME with [PAGE DOWN].
A page for naming the effect libraries opens.
fig.08-009
The subsequent operations are identical to those used to name the input channels.
For details, see “Naming input channels” (p. 83).
To jump to the same screen
for another effect, hold
down [EFFECTS1-8] and
press the numeric key ([1]–
[8]) for the corresponding
effect.
After you have edited the
effects, you can proceed to
the Set Name screen
(NAME) by pressing
[PAGE DOWN] repeatedly
when you are in the
[PARAM-1], [PARAM-2],
or [ASSIGN] page of the
Edit screen.