Owner`s manual

143
Chapter 8 Using the Internal Effects
Chapter 8 Using the
Internal Effects
Parameter (full name) Setting Function
Flanger: Adds effect similar to ascending/descending sound of a jet.
Sw (Switch) On, Off Turns the flanger on or off.
Rate (Rate) 0.1–10.0 Hz Sets the rate at which the flanger is modulated.
Depth (Depth) 0–100 Sets the depth of modulation.
Manual (Manual) 0–100 Sets the center frequency subject to application of the
Flanger effect.
Reso (Resonance) 0–100 Enhances frequency components at around the center
frequency set with Manual. *1
Effect level (Effect Level). -100–100 Sets the volume of the flanger sound.
Direct Level (Direct Level) -100–100 Sets the volume of the direct sound.
CrossFB Level (Cross-Feedback Level) 0–100 Sets the amount of the flanger sound to be returned to the
channel opposite to the one used for input. *2
Polarity (Polarity) Sync, Inv Sets the right and left phases of modulation. *3
3 BAND EQ (Equalizer)
Sw (Switch) On, Off Turns the equalizer on or off.
Hi Gain (High Gain) -12– +12 dB Sets the boost/cut amount in the high frequency band.
Hi Freq (high frequency) 1.4–20.0 kHz Sets the center frequency in the high frequency band.
Hi Q (High Q) 0.3–10.0 Sets the width of the area around the high frequency that
will be affected by the gain settings. *4
Hi Type (High Type) Shelv, Peak Sets the type of the high frequency band equalizer
(shelving type or peaking type).
Mid Gain (Middle Gain) -12– +12 dB Sets the boost/cut amount in the middle frequency band.
Mid Freq (middle frequency) 200–8000 Hz Sets the center frequency in the middle frequency band.
Mid Q (Middle Q) 0.3–10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Lo Gain (Low Gain) -12– +12dB Sets the boost/cut amount in the low frequency band.
Lo Freq (low frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Lo Q (Low Q) 0.3–10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings. *4
Lo Type (Low Type) Shelv, Peak Sets the type of the low frequency band equalizer
(shelving type or peaking type).
Output Level (Output Level) 0–100 Sets the volume after passing through equalizers.
*1: An excessively great values for Resonance (Reso) may cause oscillation.
*2: An excessively large value for Cross-Feedback level may cause oscillation.
*3: When a mono source has been input, set “Inv” to provide spaciousness to the sound. Set “Sync” for inputting a
stereo source.
*4: If Low Type (Lo Type) or High Type (Hi Type) is set to “Shelv (Shelving Type),” the setting for Lo Q or High Q
is invalid.
Frequency (p. 237), Q (p. 243), Shelving Type (p. 244), Peaking Type (p. 242), Flanger (p. 236), Equalizer (p.236),
Resonance (p. 243), Feedback Level (p. 236)