Owner`s manual

209
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
Chapter 11 Recording/Playing Back
Fader or Knob Actions (Automix)
VIEW section
Data to be displayed in the VIEWER area are specified in this section.
SECTION: section
2ndUNIT: A second cascade-connected processor is selected.
PARAM: data type
ALL: Specify if all types of data should be/should not be
displayed in the VIEWER area.
SOURCE section
The channel subject to auto-mixing editing (source channel) is specified in this
section.
TIME/VALUE TRIM section
When you select data, you can confirm the name, location and value of the data at
the same time.
fig.11-03be
This mark indicates the location of the selected data.
This mark indicates the current position.
1. Press [AUTO-MIX] while holding down [SHIFT].
2. Press [PAGE UP]/[PAGE DOWN] to move the cursor to “VIEW.”
The AUTO MIX VIEW screen is displayed.
3. Press CURSOR [DOWN] to move the cursor over to the VIEW/SOURCE/
VALUE TRIM section.
4. When more than one processor is connected, press [F1] (2ndUNIT) to select
the processor.
5. Turn the [V1] (SECTION) knob to select the section to be displayed.
6. Turn the [V2] (PARAM) knob to select the data type to be displayed.
7. Turn the [V3] (SOURCE) knob to select the channel for confirming data.
8. Turn the [V4] (EVENTSEL) knob to confirm data one by one.
This way, you can check the data of the specified type sequentially.
5
6
7
Data Name
Position
Value
8
9
You can arrange things so
that changing the current
position would not cause
the screen to be scrolled. To
do so, set the [F5] (SYNC)
switch in the ZOOM
section off.
Turning the [V4]
(EVENTSEL) knob does not
affect the current position.