Owner`s manual

Adding the Sound with the Effect Applied to the Direct Sound (Send/Return)
When adding the sound with effect to the direct sound, such as is done with
reverb or delay, use the EFFECT bus.
With some effects, while you can have output of both the direct sound and effect
sound, it’s usually better to have the effect sound output separately. The direct
sound and effect sound are adjusted with each channel fader. The present signal
flow is shown below.
fig.05-07(sndrtn.eps)
1. Select the channels to which the effect is to be applied. Press the SELECT
buttons for the input or track channels to which you want to apply the
effect.
The button indicators light, and the Input Mixer or Track Mixer screen appears
in the display.
2. Press [F1 (EFX1)]. If “Ef1In” does not appear in [F1], first press [PAGE] until
“EFX1” is displayed, then press [F1 (EFX1)]. Alternatively, use [ ], [ ],
[ ], and [ ] to move the cursor to “EFX1.”
fig.05-08(channelsnd.eps)
3. Use [ ] and [ ] to move the cursor. Rotate the TIME/VALUE dial.
Sw (Effect Send Switch)
This selects the how the signal is sent to the EFFECT bus (send).
Off: The signal is not sent.
Pre: The sound before passing through the channel fader is sent.
Pst: The sound after passing through the channel fader is sent.
Level
(Fader)
EQ
(2band, 3band)
EFX1
Sw
Send
Level
Pan
EFX2
Sw
Send
Level
Pan
EFX3
Sw
Send
Level
Pan
EFX4
Sw
Send
Level
Pan
AUX
Sw
Send
Level
Pan
Pan
EFX1
EFX2
EFX3
EFX4
MIX bus oe REC bus
MIX bus oe REC bus
MIX bus oe REC bus
MIX bus oe REC bus
MIX bus oe REC bus
AUX bus
Effect Send Switch
Effect Send Level
Effect Send Pan
Chapter 5 Using the Internal Effects (VS8F-2)
106