Owner`s manual

10. This display appears as shown below. Check each
of the capacity. At this time, if you move the cur-
sor to “L-ch Source Track” or “R-ch Source
Track,” you can switch each of the by rotating the
TIME/VALUE dial.
fig.07-06(capa.eps)
* If the “space required for the song being written to the
CD-R disc” exceeds the total of the “free space on the
internal IDE hard disk” and the “free space on the CD-R
disc,” you cannot write the song to the CD-R disc.
* The used capacity of the song is displayed as 1 MB =
1,000,000 bytes. The displayed value is the approximate
standard value.
11. Press [ ], [ ], [ ], and [ ] to move the
cursor to “Finalize,” and rotate the TIME/VALUE
dial.
Finalize
To make CD-R discs prepared with the VS-1680
playable on ordinary CD players, a TOC (Table of
Contents) must be written. Nothing beyond this can be
written to finalized CD-R discs.
TOC (Appendices p. 65)
Off: The song is written without the finalize proce-
dure being carried out.
On: After the song is written, the finalize proce-
dure is performed.
OnlyFin.: Only the finalize procedure is carried out,
without the song being written.
12. Press [F4 (Exec)].
A confirmation message appears in the display.
13. Press [YES].
A message with the licensing conditions appears in
the display. After reading this carefully, if you agree to
the conditions, press [YES].
This message also appears in the back cover of this
manual. Writing to the CD-R disc begins. If you do not
agree to the terms, press [NO]. Return to the Step 2.
14. After writing of the CD-R disc is correctly per-
formed, “Write Another?” appears in the display.
If you wish to write the same song data to another
CD-R disc, place a new disc in the drive and press
[YES]. Press [NO] to return to the Step 2.
Internal IDE hard disk free space
Length of the song which is to be written to the CD-R disc
Disk space occupied by a song when written to a CD-R disc
Number of Markers used for track numbers
CD-R disc free space
Size of the content written to the CD-R disc
Number of tracks after writing to the disc is finished
Determining whether or not the CD-R disc has data written to it
Track which you want written as the right track
Track which you want written as the left track
Song Name
Disk space required for the song being
written to the CD-R disc
The disk space occupied by a song when written
to a CD-R disc may not be equivalent to the size
of the song itself. This is something that varies
with the number of tracks and recording mode
used. You can make a rough estimate of the space
required for a song when written to a CD-R disc
as shown below.
Size (bytes) = 44,100 (Hz) x 2 (stereo tracks) x 2
(bytes) x “song length” (in seconds)
If “Not 44.1k Song!” Appears in the
Display
The sample rate is not 44.1 kHz, so the song can-
not be written to the CD-R disc. Press [ENTER
(YES)] to return to Step 1. Please refer to
“Creating a New Song” (p. 58).
If “Please Insert Disc!” Appears in the
Display
This indicates that the CD-R drive’s loading tray
is open, that there is no disc loaded, or that the
CD-R drive is in some other way not ready for
use. Insert a CD-R disc, and press [YES].
Chapter 7 Use with a CD-R Drive
122