Owner`s manual

6. Songs that are marked are loaded. Use the
TIME/VALUE dial to move the cursor to the
songs you want to restore and press [F4 (MARK)].
By pressing [F3 (ALL)], you can place and remove
marks from all of the songs simultaneously. In
addition, you can press [F2 (SelSg)] to display a
directory of the songs. At this point, after you
have placed a Marker at the song you want, press
[F1 (Back)].
fig.07-19(cdr_rc_selsg.eps)
7. Press [ ] to move the cursor to “Erase All
Song.”
Erase All Songs
When this is set to “On,” the recover procedure is car-
ried out after the destination drive is initialized. If you
want to perform the recover procedure leaving songs
already saved in the current drive as they are, then set
this to “Off.”
8. Press [F4 (Exec)].
A message asking for confirmation appears in the dis-
play.
9. Press [YES].
“STORE Current?” (Store the current song?) appears
in the display.
10. If you wish to save the current song, press [YES];
if not, then press [NO]. If you have selected a
demo song, then press [NO].
11. Execute the load. When over multiple discs, the
disc is ejected, “Insert Disc #” (# indicates the
number in the order of insertion) appears in the
display. Insert the next disc and press [YES].
12. When the CD-R backup procedure is finished,
return to Play condition.
Chapter 7 Use with a CD-R Drive
127
Chapter 7