Owner`s manual

5. Press [F4 (Exec)].
6. A confirmation message appears on the screen.
Press [YES]. If you wish to cancel the procedure,
then press [NO].
7. ”STORE Current?” (Store the current song?)
appears in the display. If you wish to save the cur-
rent song, press [YES]; if not, then press [NO].
8. When Song Combine is executed, return to Play
condition.
Adjusting the Levels for Each
Track
You can adjust the volume level of each input and
track channel without using the channel faders. You
can raise the volume when playing back tracks that
were recorded at low levels, avoid distorted sound
that may occur when adjusting the channel equalizers,
and be able to operate with the channel faders near 0
dB. Use the following procedure.
1. Press the SELECT button for the input or track
channels whose volume levels you wish to adjust.
2. Press [F2 (ATT)]. If “ATT” does not appear in
[F2], first press [PAGE] until “ATT” is displayed,
and then press [F2 (ATT)].
3. Rotate the TIME/VALUE dial.
fig.11-40(att.eps)
ATT (Attenuation)
Adjusts the volume level (-42–6 dB) of each channel’s
digital signal.
4. Press [PLAY (DISPLAY)].
Return to Play condition.
When Using Balanced Inputs
The VS-1680 features balanced (TRS) INPUT jacks,
each one configure as follows.
fig.11-41(trs.eps)
However, some audio devices have the opposite HOT
(TIP) and COLD (RING) configuration. Using such
equipment as is may result in poor sound placement,
disintegration of the left-right balance, and a loss of
the separation between left and right sounds when
using stereo inputs. In such instances, you need to
switch the phase of each channel.
1. Press the SELECT button for the input or track
channels whose phase you wish to switch.
2. Press [F3(Phase)]. If “Phase” does not appear in
[F3], first press [PAGE] until “Phase” is displayed,
and then press [F3 (Phase)].
Attenuation
Chapter 11 Other Convenient Functions
174