Owner`s manual

Selecting Pages Contained in
Functions and Settings
The menu icon for each page is displayed. Press the
function button ([F1]–[F6]) that corresponds to the
page you want. When menu icons appear on several
pages, press [PAGE].
fig.02-01d(icons.eps)
When you want to changes settings for each mixer,
press the corresponding button, as shown below.
Input Mixer condition:
SELECT button for each input channel (1–8, DIGITAL,
ST IN, EFFECT 1 RTN, EFFECT 2 RTN)
Track Mixer condition:
SELECT button for each track channel (1–16)
Master Block condition: [MASTER]
fig.02-03(mix_edit.eps)
Select the Setting You Want to Change
Using [ ], [ ], [ ], and [ ], move the cursor
to the setting (parameter) you want to change. Use the
function button if there is more than one page.
The function buttons can be used to directly move the
cursor for the settings for each mixer.
fig.02-05(cursor2.eps)
Change the Settings Values
Use the TIME/VALUE dial for this operation.
Rotating the dial counterclockwise decreases the val-
ues, rotating clockwise increases them. Although usu-
ally, increases and decreases in values are in single
unit steps, by holding down [SHIFT] while rotating
the TIME/VALUE dial, depending on the parameter,
you can make values increase or decrease ten times (or
one tenth) the normal rate.
fig.02-06(dial.eps)
Execute the Operation
After changing the value, to create the new song,
select the different song, or otherwise set or execute
the specified task or operation, press [YES]. A confir-
mation message will appear in the display. When the
message appears, press [YES]. If you want to cancel
the operation, then press [NO].
Input Mixer
Track Mixer Master Block
Cursor
decrease increase
Chapter 2 Basic Operation
35
Chapter 2
When Selecting System Condition
When selecting System condition, rather than
selecting a menu icon, the parameters themselves
may be displayed. This allows immediate selection
of previously changed parameters. If you want to
display the menu icons, press [F6 (EXIT)].
fig.02-02(exit.eps)
Cursor
(previously changed parameters)
If you want the menu to be displayed