Owner`s manual

Storing Recording Settings (Recording)

Select this when you want to record the performance input via the INPUT jacks.

If you wish to cancel the settings procedure, press [F6 (EXIT)].

1. Press [EZ ROUTING].

The EZ Routing icon appears in the display.

2. Press [F4 (Exec)]. If “Exec” does not appear in [F4], first press [PAGE] until

“Exec” is displayed, and then press [F4 (Exec)].

fig.02-18(ez_con(rec).eps)

3. Press [F1 (Rec)].

4. Specify which source is to be recorded on each track. First press the source

input channel SELECT button, then press the track channel STATUS button

for the track to which the source is to be recorded. With the EZ Routing, you

can assign a single source to be recorded on up to two tracks. Additionally,

by pressing the SELECT button when the input is not assigned to any track,

you can have the source assigned to the MIX bus (the signal is not record-

ed). Press [ ] and [ ] to move the cursor. Rotate the TIME/VALUE

dial to select the V-track to which you want the source recorded.

* Sources that have Stereo Link set to “On” cannot be recorded to tracks on which

Stereo Link is set to “Off” with the EZ Routing.

fig.02-19(rec_step1.eps)

Chapter 2 Basic Operation