Owner`s manual
Using Locators:
1. Preset locate points where you want to punch
in/punch out.
2. While holding down [AUTO PUNCH], press the
LOCATOR button specifying the locate point for
the time at which you want to punch in.
3. Then, without releasing [AUTO PUNCH], press
the LOCATOR button specifying the locate point
for the punch-out time.
fig.03-12(p_io_locate.eps)
Using Markers:
The space between two adjacent mark points can be
used to define the segment for Punch-In Recording.
1. Preset Markers where you want to punch in and
then punch out.
2. Move to the mark point located at the desired
punch-in time.
3. While holding down [AUTO PUNCH], press
[NEXT].
4. Without releasing [AUTO PUNCH], press [PREVI-
OUS].
fig.03-13(p_io_mark.eps)
Specifying the Points While the Song Plays
Back:
1. Press [PLAY] to begin playback of the song.
2. When you reach the desired punch-in location,
hold down [AUTO PUNCH] and press [TAP].
3. Continue holding down [AUTO PUNCH], wait for
the desired punch-out location, and then press
[TAP] once again.
4. Press [STOP].
fig.03-14(p_io_tap.eps)
Making Fine Adjustments to the Punch-In
Segment:
1. Hold down [SHIFT] and press [AUTO PUNCH].
fig.03-15a(apunch_io.eps)
2. The punch-in and punch-out locations appears in
the display. Use [ ] and [ ] to move the cur-
sor to the mark point you want to adjust.
However, if no mark point is stored at the current
location, “–h–m–s–f– —–” appears in the display.
At this time, the function buttons work as shown
below.
[F1 (In)]: Moves the cursor to the punch-in location.
[F2 (NOW)]: Enters the current time as the punch-
in/out point.
[F3 (JUMP)]: Moves the time to the punch-in/out point.
[F4 (Out)]: Moves the cursor to the punch-out location.
[F6 (EXIT)]: Exits the screen.
3. Enter the located point where you wish to change
with the TIME/VALUE dial.
4. When you are done making the changes, press [F6
(EXIT)].
The utility menu screen appears in the display.
Alternatively, press [PLAY (DISPLAY)]. Return to
Play condition.
Chapter 3 Multi-Track Recording
65
Chapter 3










