Owner`s manual

Using Locators:
1. First store locate points where you want to begin
and end the loop.
2. While holding down [LOOP], press the LOCATOR
button for the locate point where you want the
loop to begin.
3. Without releasing [LOOP], press the LOCATOR
button which specified the end of the loop.
fig.03-18(lp_locate.eps)
To Use Markers:
Adjacent mark points can be used to set the beginning
and end of the loop.
1. First, set mark points where you want to punch in
and punch out.
2. Move to the mark point at the beginning of the
loop.
3. While holding down [LOOP], press [NEXT].
4. Without releasing [LOOP], press [PREVIOUS].
fig.03-19(lp_mark.eps)
Specifying The Points While the Song Plays
Back:
1. Press [PLAY] to begin playback of the song.
2. When you reach the desired location for the begin-
ning of the loop, hold down [LOOP] and press
[TAP].
3. Continue holding down [LOOP], and when you
reach the desired location for the end of the loop,
press [TAP] once again.
4. Press [STOP].
fig.03-20(lp_tap.eps)
Making Fine Adjustments to the Loop:
1. Hold down [SHIFT] and press [LOOP].
fig.03-21a
2. The loop start and loop end points appear in the
display. Use [ ] and [ ] to move the cursor
to the point you want to adjust. However, if no
mark point is stored at the current location,
“–h–m–s–f– —–” appears in the display.
At this time, the function buttons work as shown
below.
[F1 (Start)]: Moves the cursor to the loop start
point.
[F2 (NOW)]: Enters the current time as the loop
start/end point.
[F3 (JUMP)]: Moves the time to the loop start/end
point.
[F4 (End)]: Moves the cursor to the loop end
point.
[F6 (EXIT)]: Exits the screen.
3. Enter the mark point you want to adjust with the
TIME/VALUE dial.
4. When you are finished making the changes, press
[F6 (EXIT)].
The utility menu icon appears in the display.
Alternatively, press [PLAY (DISPLAY)]. Return to
Play condition.
Chapter 3 Multi-Track Recording
67
Chapter 3