Owner`s manual

Applying Effects While Recording
(Send/Return)
Now we will see how to add affects to the source at
the INPUT 8 jack, and then record the direct sound
and the sound with effects to Track 8. This is conve-
nient when you want to record vocals with reverb.
Select the Effect:
1. Hold down [SHIFT] and press [F3 (EFFECT A)].
The Effect A menu appears in the display.
2. Press [F1 (EFX1)].
The Effects1 settings screen appears in the display.
3. Select the effect. Press [F2 (Sel)].
The effects list appears in the display.
4. Use the TIME/VALUE dial to move the cursor to
the effect you wish to use. Here, select “P000
RV:LargeHall.”
At this point, the function buttons work as shown
below.
fig.03-26(effectsel.eps)
[F1 (Preset)]: Displays the Preset patch list.
[F2 (User)]: Displays the User patch list.
[F4 (Exec)]: Exits the screen after selecting the
effect.
[F6 (EXIT)]: Exits the screen without selecting the
effect.
5. After selecting the effect, press [F4 (Exec)].
The Effects1 settings screen reappears in the display.
6. Press [PLAY (DISPLAY)]
Return to Play condition.
Specify the Input Channel to Which the Effect
is to be Applied:
7. Press the Input Channel 8 SELECT button for the
track to which you want to apply reverb.
The button indicator lights, and the Input Mixer screen
appears in the display.
8. Press [F1 (EFX1)]. If “EFX1” does not appear in
[F1], first press [PAGE] until “EFX1” is displayed,
then press [F1 (EFX1)].
fig.03-27(eff.eps)
9. Press [ ] and [ ] to move the cursor. Use the
TIME/VALUE dial to set the effect switch, send
level, and pan settings for each track channel.
Sw (Effect Switch)
This sets how the signal is sent to the EFFECT bus. In
this case, select “Pst.”
Off: The signal is not sent.
Pre: The sound before passing through the channel
fader is sent.
Pst: The sound after passing through the channel
fader is sent.
Lev (Send Level)
This adjusts the level of the signal (0–127) sent to the
EFFECT bus.
Pan (Send Pan)
This adjusts the stereo placement of the signal
(L63–0–R63) sent to the EFFECT bus.
10. Hold down [REC] and press the Track 8 STATUS
button.
The button indicator blinks red.
11. While holding down the Track 8 STATUS button,
press the Input Channel 8 SELECT button and
[EFFECT1 RTN] for Input Channel.
The button indicator blinks. At this point, the mixer is
set up so that both the direct sound and the sound
with effects can be recorded to Track 8.
12. Record and check the content as described in
“Recording to the Tracks” (p. 61).
If “No Effect Board” Appears in the
Display
This indicates there is no VS8F-2 installed. In this
case, you cannot use the internal effects.
If the message appears even when a VS8F-2 is
installed, it indicates that the effect expansion
board has not being recognized properly.
Perform the shutdown procedure and turn the
power off as described in “Turning Off the
Power” (p. 32), then reinstall the VS8F-2 correctly.
Current EffectCursor
Function Buttons
Effect Send Switch
Effect Send Level
Effect Send Pan
Chapter 3 Multi-Track Recording
71
Chapter 3