Owner`s manual

12. Press [PAGE] until “Pan” is displayed in [F1], then press [F1 (Pan)].
fig.03-31(pan.eps)
13. Press [ ] and [ ] to move the cursor. With the TIME/VALUE dial, set
the Switch and Pan settings for Input Channel 8.
(Master Send Switch)
When this is set to “On,” the source from each input channel, rather than being
assigned to the recording bus, is sent directly to the MIX bus. Set this to “On”
when, for example, you simply want to mix the inputs without recording them.
However, the sources that are assigned to the RECORDING bus are disabled.
(Master Send Pan)
This adjusts the pan setting (L63–0–R63) of the signal sent to the MIX bus and
the RECORDING bus. For now select "R63."
14. Press the Input Channel 7 SELECT button.
15. Repeat the Steps 9–13 to make the settings for Input Channel 7 as same as
those for Input Channel 8. However, select “InsL” and “L63” for Steps 11
and 13, respectively.
16. Now the setup is completed. In this case, the signal flow will be as the fol-
lows.
fig.03-32(insrec.eps)
Master Send Switch
Master Send Pan
Level
(Fader)
EQ
(2band, 3band)
Pan
Snd
Level
Rtn
Level
Level
(Fader)
EQ
(2band, 3band)
Pan
Snd
Level
Rtn
Level
EFX1
(InsL)
(InsR)
Input Channel 7
Input Channel 8
Level
(Fader)
EQ
(2band, 3band)
Pan
MASTER OUT
TRACK
9-1
9-2
9-3
9-4
9-5
9-6
9-7
9-8
9-9
9-10
9-11
9-12
9-13
9-14
9-15
9-16
STATUS
MIX bus
REC bus
Track Channel 9/10
Chapter 3 Multi-Track Recording
73
Chapter 3