Owner`s manual

Select the Master Clock
Synchronize the VS-1680’s reference clock (the master
clock) with the digital signal from the digital audio
device.
1. Hold down [SHIFT] and press [F5 (SYSTEM)].
The System menu icon appears in the display. If the
System menu icon does not appear, then press [F6
(EXIT)].
2. Press [F1 (SYSPM)]. If “SYSPM” does not appear
in [F1], first press [PAGE] until “SYSPM” is dis-
played, press [F1 (SYSPM)].
3. Pressing [ ], [ ], [ ], and [ ] to move
the cursor to “MasterClk.”
If “MasterClk is not displayed, then press [F1 (Prm 1)].
fig.03-33(master.eps)
MasterClk (Master Clock)
This sets the VS-1680’s reference clock.
DIGIN1: Based on the digital signal received from the
DIGITAL IN 1 connector (coaxial).
INT: Based on the VS-1680’s reference clock.
DIGIN2: Based on the digital signal received from the
DIGITAL IN 2 connector (optical).
4. Select “DIGIN1” or “DIGIN2” with the
TIME/VALUE dial.
5. Press [PLAY (DISPLAY)].
Return to Play condition.
Adjusting the Tone
(Equalizer)
A two-band (low, high) or three-band (low, mid, high)
parametric equalizer is provided for each channel.
First make equalizer adjustments separately for each
channel. If you have recorded any stereo pairs, be sure
that the same settings are made for both tracks. Then,
while paying attention to the overall balance, make
final adjustments for equalizer, pan, and volume level
for each channel.
* If you adjust the equalizer while listening to the sound,
you may notice a clicking noise. This is not a malfunction.
If the noise is objectionable, make adjustments while the
sound is not playing.
1. Press the SELECT button for the track whose
equalizer setting you wish to adjust.
The button indicator lights, and the Track Mixer
screen appears in the display.
2. Press [F2 (Low)]. If “Low” does not appear in [F2],
first press [PAGE] until “Low” is displayed, and
then press [F2 (Low)].
3. Press [YES].
If “Digital In Lock” is Displayed
This indicates that the reference clock for the sam-
ple rate is set by the digital signal from the DIGI-
TAL IN connector. You can record using the digi-
tal connection.
If “Digital In Unlock” is Displayed
This indicates that no digital signal is being
received from the DIGITAL IN connector.
Alternatively, it may indicate that the sample rate
selected for the song does not match the sample
rate of the digital device connected to the DIGI-
TAL IN connector. In this state, you cannot
record using the digital connection.
Chapter 3 Multi-Track Recording
75
Chapter 3
To Prevent Digital Connections with CD
Players
Use the following procedure when you want to
prevent digital connections with CD players.
1. Hold down [SHIFT] and press [F5 (SYSTEM)].
The System menu icon appears in the display. If
the System menu icon does not appear, then press
[F6 (EXIT)].
2. Press [F2 (GLOBL)]. If “GLOBAL” does not
appear in [F2], first press [PAGE] until
“GLOBL” is displayed, and then press [F2
(GLOBL)].
3. Press [ ], [ ], [ ], and [ ] to move
the cursor to “CD Digital Record.”
4. Rotate the TIME/VALUE dial to select “Off.”
5. Press [PLAY (DISPLAY)].
Return to Play condition.