Owner`s manual

Specify the Track to Which the Effect is to be Applied:
6. Press the Track Channel 5 SELECT button.
The button indicator lights, and the Track Mixer screen appears in the display.
7. Press [F1 (EFX1)]. If “EFX1” does not appear in [F1], first press [PAGE] until
“EFX1” is displayed, then press [F1 (EFX1)].
8. Press [F6 (PRM.V)].
The effects settings status for all tracks can be viewed.
fig.03-40(eff_prm.eps)
9. Press [ ], [ ], [ ], and [ ] to move the cursor. Use the
TIME/VALUE dial to make the effect switch, send level, and pan settings
for each track channel.
Sw (Effect Switch)
This sets how the signal is sent to the EFFECT bus. In this case, select “Pst.”
Off: The signal is not sent.
Pre: The sound before passing through the channel fader is sent.
Pst: The sound after passing through the channel fader is sent.
Lev (Send Level)
This adjusts the level of the signal (0–127) sent to the EFFECT bus.
Pan (Send Pan)
This adjusts the stereo placement of the signal (L63–0–R63) sent to the EFFECT
bus.
Specify the Tracks for Playback and Recording:
10. Hold down [STOP] and press the STATUS buttons for Tracks 5–8.
The button indicators light green.
11. Press the STATUS button for Track 9/10, so that the button indicator light
orange.
12. Hold down the STATUS button for Track 9/10 and press the Track Channel
SELECT buttons for Tracks 5–8.
The button indicators start blinking.
Effect Switch
Send Level
Send Pan
Track 1
Chapter 3 Multi-Track Recording
79
Chapter 3