Owner`s manual

START (Start point)
Specifies the starting time of the move range.
END (End point)
Specifies the ending time of the move range.
FROM (From point)
Specifies the time of the move source playback data in relation to the
To point. Normally you will set this to be the same as the Start point.
+Insert
When this is set to “On,” first, a blank space is inserted
in the specified range, and then the move is carried out.
fig.04-12(tr_mv_ins)
TO (To point)
Specifies the reference time of the move destination.
11. Press [F4 (Exec)].
This executes Track Move.
12. When the move is completed correctly,
“Complete” appears in the display.
13. Press [PLAY (DISPLAY)].
Return to Play condition.
Exchanging Performance Data
Between Tracks (Track Exchange)
This operation exchanges the playback data
of two tracks.
fig.04-14(tr_xch.eps)
1. Select the V-track containing the source playback
data to be exchanged.
2. Hold down [SHIFT] and press [F2 (TRACK)].
3. Press [F1 (Tr/Ph)] so that Track Edit menu
appears in the display.
4. Press [F4 (Xchg)]. If “Xchg” does not appear in
[F4], first press [PAGE] until “Xchg” is displayed,
and then press [F4 (Xchg)].
A
Start End To Time
A'
Track1
Track2
Track1
Track2
A
A
B
B
C
C
D
D
E
E
Time
Example: Exchanging tracks 1 and 2
Chapter 4 Editing a Recorded Performance (Track Editing)
86
Using FROM Effectively
Normally, the data is copied starting at the speci-
fied move destination time. However, if you want
to have the move made with reference to a point
within the designated range where a specific
sound occurs, set this with “FROM.”
For example, suppose that you wish to move a
sound effect of a time bomb ticking and then
exploding, and that you want to place the explo-
sion at a specific timing location. Normally, in
order to specify the move destination time, you
would have to calculate the time until the explo-
sion occurs. In such cases, however, you can spec-
ify “FROM” as “the move source time at which
the explosion begins” and “TO” (the reference
time of the move destination) as “the move desti-
nation time at which you want the explosion to
occur.” This lets you move the data with the
explosion placed with precisely the right timing.
fig.04-11(tr_mv_from.eps)
C
C
Start End To Time
From
Example3: Moving using the “FROM” setting