Owner`s manual

6. Press [F1 (Back)].
7. Press [ ], [ ], [ ], and [ ] to move the
cursor. Set each of the values.
fig.04-19(tr_ins_prm)
START (Start point)
Specifies the starting time of the performance data
that you wish to insert a blank space.
TO (To Point)
This specifies the point to which the performance data
designated by “START” is moved.
All V.Tracks (All V-Tracks)
Normally, blank spaces can be inserted in the tracks
that are audible. If you wish the same blank space to
be inserted in all tracks, set this to “On.”
8. Press [F4 (Exec)].
This executes Track Insert.
9. When the insert is completed correctly,
“Complete” appears in the display.
10. Press [PLAY (DISPLAY)].
Return to Play condition.
Deleting Performance Data (Track Cut)
This operation cuts playback data from the
specified area. When playback data is cut
using this operation, any playback data fol-
lowing the data that was cut will move forward to fill
the gap. To use the analogy of a tape recorder, this
operation is like cutting an unwanted portion out of
an audio tape, and splicing the ends.
fig.04-21(tr_cut.eps)
* Do not leave sound within 0.5 seconds before or after the
area to be cut. Any sound within 0.5 seconds of the cut
data will not be played back.
* While it may seem that the performance data has disap-
peared, the data itself is not deleted from the hard disk.
Thus, even when you carry out the Track Cut procedure,
the free disk space shown in the display does not change.
1. Hold down [SHIFT] and press [F2 (TRACK)].
2. Press [F1 (Tr/Ph)] so that Track Edit menu
appears in the display.
3. Press [F6 (Cut)]. If “Cut” does not appear in [F6],
first press [PAGE] until “Cut” is displayed, and
then press [F6 (Cut)].
4. Press [F1 (SelTr)].
5. Press the SELECT button for the track on which
you want to carry out Track Cut.
The button indicator lights red.
Alternatively, press [ ], [ ], [ ], and [ ] to
move the cursor to the track on which you want to
carry out Track Cut, and then press [F3 (MARK)] or
[YES].
This cuts the performance data on the track containing
the mark. When [F2 (ALL)] is pressed, you can place
or remove the marks on all the tracks simultaneously.
fig.04-22(tr_cut_sel)
6. Press [F1 (Back)].
TimeStart End
A
Chapter 4 Editing a Recorded Performance (Track Editing)
88