Owner`s manual

7—Mixer Views
72 www.RolandUS.com Roland VS-2480 Owner’s Manual, Version Two Addendum
7. DIR (DIRECT) 1-8 Selector
8. MUTE (M) Button
9. SOLO (S) Button
10. AUTOMIX STATUS (A) Button
11. GRP (GROUP) Selector
12. PAN Knob
13. Channel Fader
14. LINK Switch
To route the channel’s signal to a Direct bus, click the desired bus’s
number.
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel’s Automix status.
To assign the channel to a fader group, click beneath “GRP” and
select the desired fader group from the pop-up menu.
Set the stereo position of the channel in the main MASTER bus mix by
dragging the PAN knob up or down as desired.
The position of the fader sets the level of signal coming out of the
channel. Moving the onscreen fader is the same as moving the
channel’s physical fader on the VS-2480.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu, or turn off linking. The LINK switch occupies the
combined lower edge of both of the channels it controls.
156
142
142
327
155
156
154
152, 155