Owner`s manual

7—Mixer Views
Roland VS-2480 Owner’s Manual, Version Two Addendum www.RolandUS.com 75
9. SOLO (S) Button
10. AUTOMIX STATUS (A) Button
11. PHRASE SEQ STATUS Button
12. GRP (GROUP) Selector
13. PAN Knob
14. TRACK STATUS Button
15. Channel Fader
16. LINK Switch
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel’s Automix status.
When the phrase sequencer is activated and the track’s phrase pad
is turned on, you can set its phrase sequencer track status by
repeatedly clicking the PHRASE SEQ STATUS button.
To assign the channel to a fader group, click beneath “GRP” and
select the desired fader group from the pop-up menu.
Set the stereo position of the channel in the main MASTER bus mix by
dragging the PAN knob up or down as desired.
Click a TRACK STATUS button repeatedly to set its track’s status—
this is the same as pressing the corresponding physical TRACK
STATUS button on the VS-2480.
The position of the channel fader sets the level of signal coming out of
the channel. Moving the onscreen fader is the same as moving the
channel’s physical fader on the VS-2480.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu, or turn off linking. The LINK switch occupies the
combined lower edge of both of the channels it controls.
142
327
275
155
156
178
154
152, 155