User`s manual
Fully Utilize the Media Heating System
4
Part of
Practice
101
Description
By default setting, simply switching on the power does not make the media heating system warm up to the
preset temperature. The temperature rises until preset temperature when the media is loaded correctly and
lights up. You can also make this setting on the RIP software. When you have made the setting on
the software, the software's setting is used.
Depending on the usage environment, the temperature of the print heater or dryer may become higher
than the preset temperature, but this does not represent a problem.
For Hints and Tips for Temperature Setting, refer to the next page
Hints and Tips for Temperature Setting
The relationship between the print mode and temperature
The optimal temperature for the media heating system varies according to such factors as the type
of media and dierences in the print mode. If smudging or poor drying occur even after raising the
temperature, try using a print mode of RIP software oering higher image quality.
Conversely, when you want to use a faster print mode, raise the temperature.
Amount of ink
When you change the amount of ink using the settings for your software RIP, adjusting this may yield
better results. If problems such as smudging persist even after raising the temperature, try reducing
the amount of ink.
Other points to remember
When recommended settings for temperature, print mode, and other values are given as the use
condition of your media, use the suggested settings.