User`s manual

Fully Utilize the Media Heating System
4
Part of Practice
103
Description
 "ENABLE" : media feed is performed until the trailing edge of the printing area is positioned on the dryer.
The margin between the print-end position and the next print-start position is set to a value of 100 mil-
limeters. When a margin setting of less than 100 millimeters has been made on the RIP software computer,
that setting is ignored, but when a margin setting of greater than 100 millimeters has been made on the
computer, the computer's setting is used for the margin value.
 "DISABLE" : media feed stops simultaneously when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
Setting the Drying Time after Printing
Procedure

Press .

Press several times to display the left gure.
Press
, and then .

Press .

Press to select the interval.
Press
to enable the setting.

Press to go back to the original screen.
Description
Set the interval after the 1st page is printed. The next operation is not started until the set time passes.
is lighting during the interval. When pressing while is lighting, the interval is nished and
the next operation is started. When holding on
while is lighting, output is canceled.
Default Setting
[DRYING TIME]: 0 min
MENU
HEATER MENU
HEATER MENU
DRYING TIME
DRYING TIME
0min � 10min
W1200mm
SETUP SHEET