User`s manual

Fully Utilizing Cutting Function

Part of

Practice

115

Fine-tuning the Cutting Conditions

Procedure



Performing the Cutting Test

 P. 60, "Setting The Cutting Test And The Blade Force"Procedure

When cutting of the test patterns is completed, press .



Press to select the set cutting condition.

Press

[Force]

This sets the force (pressure) of the blade. (Default Setting 50gf)

[Speed]

This sets the speed of cutting. Default Setting: 30 cm/s)

[OFFSET]

This makes the blade-oset setting for the blade. Enter the listed oset value for the blade. (Default

Setting: 0.250 mm)

[UP-SPEED]

This sets the blade's up speed during cutting (the speed at which the blade travels when it moves to the

next cutting line after cutting one cutting line). If the media comes loose during no-load feed and the

blade damages the surface of the media, reduce the speed. (Default Setting: 30 cm/s)



Press to select a value.

Press

to enable the setting.

For information on the evaluation method of cutting test, refer to the next page.

CUT CONFIG

FORCE

50 gf 60 gf