User`s manual

Fully Utilizing Cutting Function
4
Part of Practice
120

Press to display the left gure.
Press
.

Press to select a correction value of [F] (feed
direction of media).
Press
to select a correction value of [S] (move-
ment direction of head).
Press
to enable the setting.

Press in this order to display the left gure.
Press
.
The test pattern (P&C1) is printed and cut. If the printing and cutting lines
are aligned, adjustment is complete. If further adjustment is needed, go
back to Procedure


and ne-tune the adjustment.
To check the test pattern (P&C2)
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction and the [FEED] side respectively.
PRINT - CUT ADJ.
SETTING
F :- 0.30 - 0.30mm
S : 0.00 - 0.20mm
PRINT - CUT ADJ.
TEST PRINT
Scan direction
[FEED]
side.
Correction-
value scale
Cutting line
For the gure, the cor-
rection value is “-0.3.”
Cutting line
Cutting
position
Printing position and Cut-
ting position are aligned.
Printing
position