User`s manual

Performing Printing and Cutting Separately
4
Part of Practice
126
If Automatic Alignment Cannot Be Performed
If the machine fails to detect the crop marks, the screen shown in the
gure appears and operation stops. Press then the screen
goes back to the previous screen. Reload the media, and then send
the data again. Reload the media, and then send the data again.
*When you want to perform automatic alignment with lengthy media, we recommend performing
output with the data separated into sizes that are as short as possible.
The crop marks cannot be detected easily because of the eects of media warping or the like. With
large sizes, error due to warping and the like increases, making smooth detection impossible. In such
the cases, perform alignment manually.
 P. 127, “Aligning Manually and Cutting”
CROPMARK ERROR
NOT FOUND
To Quit Detection and Start Cutting
Procedure

Press during detection of crop marks.
Crop-mark detection stops. Depending on the content of the data, some time may pass
before detection actually stops.

Press .
This stops detection and starts cutting.
*Note: After pressing in Procedure  , resuming detection or canceling output
is also possible.
 P. 64, "Pausing and Canceling Output"
CANCEL CROPMARK
DETECTION?