User`s manual

Performing Printing and Cutting Separately
4
Part of Practice
128

Repeat Procedure  to  to specify other align points as required.

Send the cutting data and perform cutting.
Correcting Misalignment for Printing and Cutting When Using Crop Marks
Note: When performing this setting, make sure to set the correction value of [CUTTING MENU CALIBRATION]
to “0.00%.”
 P. 118, "Performing Distance Correction During Cutting"
Procedure

Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
 P. 122, “Viewing the Automatic Environment Correction Function Setting"

Perform bidirectional adjustment.
P. 104, " Correcting for Misalignment in Bidirectional Printing," p. 105, "Correcting for Misalignment in Bidirectional
Printing More Precisely"

Press .

Press to display the left gure.
Press
, and then .

Press .

Press .
The test pattern (C&C1) is printed and cut.
When adjustment is needed, go on to the next Procedure.
About Align Points
The numbers for align points are determined with reference to the location of the base point. You
cannot set an align point unless you specify a base point. Redoing the setting for the base point clears
any align points that have been set.
MENU
CUTTING MENU
CUTTING MENU
CROP - CUT ADJ.
CROP - CUT ADJ.
TEST PRINT
To check the test pattern (C&C1)
Check to make sure that the printing position and the cutting position are aligned.
Printing
position
Printing position and Cutting posi-
tion are misaligned.
Printing position and Cutting posi-
tion are aligned.
Cutting
position