User`s manual

155
6
FAQ
A Message Appears
These are the main messages that appear on the machine's display to prompt correct operation.
They do not indicate any error. Follow the prompts and take action accordingly.
[1 ■ 2 ■ 3 ■ 4 ■ 5 ■ 6 ■ 7 ■ 8 ■]
Only a small amount of ink remains. Replace the cartridge indicated by the ashing number with a new
cartridge.
[PRESS THE POWER KEY TO CLEAN]
This appears when the machine has been unused for about one month. Switch on the sub power once a
month.
P. 94, "When Not in Use for a Prolonged Period"
[CLOSE THE COVER (FRONT COVER, COVER L or COVER R]
Close the front cover, cover L, or cover R. For safety, the carriage does not operate while a cover is open.
[SHEET NOT LOADED SETUP SHEET]
Load media. This message appears when an attempt to perform a printing test was made while no media
was loaded.
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged uid collects in the drain bottle. To clear the message,
press
. If this screen appears, go to the [DRAIN BOTTLE] menu and discard the discharged uid in
the bottle.
 P. 70, "Disposing of Discharged Ink"
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain bottle, then press .
 P. 70, “Disposing of Discharged Ink”
[NOW HEATING...]
Wait until the media heating system reaches the preset temperature. Printing starts when lights up.
You can stop printing by holding down
for one second or longer while this is displayed. Pressing
makes printing start immediately, without waiting to reach the preset temperature.
[TIME FOR MAINTENANCE]
It is time to clean the printer heads manually. After verifying, press .
 P. 76, “Manual Cleaning of Print Head”
[TIME FOR WIPER (FELT) REPLACE]
It is time to replace the wiper or felt wiper. After verifying, press .
 P. 84, "Replacing the Wiper," p.87 "Replacing the Felt Wiper"
[SHAKE CARTRIDGE 1 2 3 4 5 6 7 8]
Remove the ink cartridge of the ashing slot number and shake it gently.
 P. 70, "Maintenance of Ink Cartridges"