User`s manual

An Error Message Appears
6
FAQ
159
[PINCHROLL ERROR INVALID LEFT POS]
The left pinch roller is positioned at a location where it does not pinch the media.
Raise the loading lever and move the left pinch roller to the correct location.
 P. 35, “Loading Media”
[PINCHROLL ERROR INVALID RIGHT POS]
The right pinch roller is positioned at a location where it does not pinch the media.
Raise the loading lever and move the left pinch roller to the correct location.
 P. 35, “Loading Media”
[PINCHROLL ERROR XXX FROM RIGHT]
The middle pinch rollers are positioned at locations where they do not pinch the media.
Raise the loading lever and move the middle pinch rollers to the correct location.
 P. 35, “Loading Media”
Too many middle pinch rollers are installed.
Raise the loading lever, then remove all middle pinch rollers that are not positioned above grit rollers. The
number of middle pinch rollers used varies according to the width of the loaded media.
 P. 35, “Loading Media”
[WRONG CARTRIDGE]
A cartridge that cannot be used was installed.
Remove the cartridge to clear the error. Use a cartridge of the specied type.
[AVOIDING DRY-UP TURN POWER OFF]
The print head was forced to standby position to prevent them from drying out.
Operation cannot be continued. Switch the sub power o, then back on.
[SET HEAD HEIGHT TO xxx]
The height of the print head is lower than the height specied on the computer.
This warning indicates that the height of the print head is too low for the media thickness specied on the
computer. The heads move to a location where you can operate the height-adjustment lever. Adjust to the
displayed height, then press
.
 P. 107, "Adjusting Head Height to Match Media Thickness"
[MOTOR ERROR TURN POWER OFF]
A motor error occurred.
Operation cannot be continued. Switch o the sub power. Next, eliminate the cause of the error, then im-
mediately switch on the sub power. If the machine is allowed to stand with the error uncorrected, the print
head may dry out and become damaged.
This error may be caused by such factors as a mistake in loading the media, a media jam, or an operation that
pulls the media with excessive force.
The media has jammed.
Carefully remove the jammed media. The print head may also be damaged. Perform head cleaning, then
perform a printing test and check the results.