User`s manual
46
Setup of Media
About [Media Setting] menu
To ensure the optimal output according to the media size and type, various setting items are provided in this
machine. However, it is hard work to perform these settings one by one referring to this document. So, this
machine provides the [Media Setting] menu that guides these settings in the interactive mode. Using this
menu, you can set all of the basic settings only by setting according to the instructions on the display.
Since the setting details can be stored as the preset menu, you can promote your operation eciently saving
the setup steps when using the same type of media. Once storing the basic settings as the preset, you can do
ne adjustment according to need.
The items set through the [Media Setting] menu can be also set individually.
Setup of Media ([Media Setting] menu)
Note: If any setting is not needed for each setting item, you can go to the next menu by selecting [NEXT].
1.
Starting the [Media Setting] menu.
Load media.
Check that no sagging is found on the media. If any sagging exists, the followed correction value settings
do not work eectively.
P. 35, "Loading Media"
Press .
When the left gure is displayed, press .
2.
Setting the Temperature of Print Heater and Dryer
Use to set the temperature.
Recommended temperature: 35 degrees (95°F)
Press to enable the setting.
Only Printing: Perform the procedure
1.
to
6.
,and
10.
,
11.
Printing & Cutting: Perform all the procedure
1.
to
11.
MENU
MEDIA SETTING
PRINT
30℃ 35℃
Current preset
temperature
Temperature
to be set
2
Basic
Operation