User`s manual

Setup of Media
50
6. Deciding to perform the setting for cutting or not
[Only Printing]
Press
to select [NEXT].
Press
to enable the setting.
Go to Procedure 10.
[Print & Cut]
Press
to select [SET].
Press
to enable the setting.
Go to Procedure 7.
7. Setting the blade force

Press to select SET].
Press
to enable the setting.
The test pattern is cut. Circle and rectangle are cut. Peal o the
two shapes.

[Two shapes are peeled off separately]
Press
to select [COMPL].
Press
to enable the setting.
Go to Procedure 8.
[Two shapes are peeled off together/backing paper is also
cut]
Press
to select [EXEC].
Press
to enable the setting.
Go to Procedure  .
CUT CONFIG
[SET] NEXT
For high-quality cutting, perform a cutting test to check the cutting quality for the media and adjust
the blade force.
CUT FORCE
[SET] NEXT
CONTINUE ADJ. ?
[EXEC] COMPL
Rectangle
Circle
2
Basic Operation