User`s manual

Setup of Media
52

[Cutting position and printing position are aligned]
Press
to select [COMPL].
Press
to enable the setting.
Go to Procedure 9.
[Cutting position and printing position are not aligned]
Press
to select [EXEC].
Press
to enable the setting.
The test pattern (P&C2) for setting the correction values is printed and cut.
Go to Procedure

.

When the left gure is displayed, press .

Check the correction values from the test pattern condition.

Use to set the correction value of [FEED] side
(F).
Use
to set the correction value of scan direc-
tion (S).
Press
to enable the setting.
The test pattern (P&C1) is printed and cut again. Check the condition of
test pattern to check that the printing position and the cutting position
are aligned.
CONTINUE ADJ. ?
[EXEC] CANCE
PLEASE INPUT
ADJ. VALUES
To check the test pattern (P&C2)
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction and the [FEED] side respectively.
F :- 0.30 - 0.30mm
S : 0.00 - 0.20mm
Scan direction
[FEED] side
Correction-
value scale
Cutting
line
For the gure,
the correction
value is “-0.3.”
Cutting
line
Current correction
value
Value to
be set
2
Basic Operation