User`s manual

Setup of Media
53

[Cutting position and printing position are aligned]
Press
to select [COMPL].
Press
to enable the setting.
Go to Procedure 9.
[Cutting position and printing position are not aligned]
Press
to select [EXEC].
Press
to enable the setting.
Go back to Procedure

and set the correction values again. Repeat
Procedure

and

until the optimal alignment is got.
For the individual setting method of this setting item and the description, refer to  p. 119, "Correcting Mis-
alignment of the Printing and Cutting positions."
9. Correcting Misalignment for Printing and Cutting Position When Using Crop Marks.

[To perform consecutive printing and cutting]
Press
to select [NEXT].
Go to Procedure10.
[To perform printing and cutting separately]
Press
to select [SET].
Press
to enable the setting.
The test pattern (C&C1) is printed and cut. Go to Procedure  .

Check the test pattern condition.
REDO ADJ. ?
EXEC [COMPL]
When you remove the printed media, and then reload it and perform cutting, use the crop marks.
For this case, correction is to be performed because the positioning of printing and cutting may be
misaligned even when you're using crop marks depending on the composition of the media.
CROP-CUT ADJ.
[SET] NEXT
To check the test pattern (C&C1)
Check to make sure that the printing position and the cutting position are aligned.
Cutting
position
Printing
position
[Cutting position and printing
position are not aligned]
[Cutting position and printing posi-
tion are aligned]
2
Basic Operation