User`s manual

Setup of Media



[Cutting position and printing position are aligned]

Press

to select [COMPL].

Press

to enable the setting.

Go to Procedure 10.

[Cutting position and printing position are not aligned]

Press

to select [EXEC].

Press

to enable the setting.

Go back to Procedure



and set the correction values again. And repeat

Procedure



and



until the optimal alignment is got.

For the individual setting method of this setting item and the description, refer to  p. 128, "Correcting Mis-

alignment for Printing and Cutting When Using Crop Marks."

10.

Setting the Drying Method and Time after Printing



Press to select the item.

Press

to enable the setting.

For the individual setting method of this setting item and the description, refer to  p. 102, "Drying the Trail-

ing Edge of the Printing Area on the Dryer."

REDO ADJ. ?

EXEC [COMPL]

FEED FOR DRY

DISABLE

ENABLE

Drying Method after Printing

After the 1st page is printed, set that the media should be fed until the trailing edge of the printed

area is positioned directly on the dryer. To make sure to dry the entire printed area, [ENABLE] If [DIS-

ABLE] is selected, the trailing edge of the printing area is not fed to the dryer unless you continue

with a subsequent printing

Current

setting

Setting af-

ter changed

Basic

Operation